| To release the hoods, insert a
screwdriver in the slits provided for the purpose and lift slightly.
Remark:
the ends of the bus conductors do not require any special handling.
The cable endpiece has beenso designed that the insulation between bus
condutors and power current conductors is ensured.
Caution:
When the cable is not laid outside a building, the shield of the bus
conductor cannot be connected to earth! |
Place
the terminal block on the flat cable
Push
on the baseplate; see to it that bus part and power current
part are well positioned (must be fitted to the cable as the
terminal block). The grooves in the terminal block and on the
baseplate show the right position for the box on the cable -
should the box have been fitted to the cable on the wrong
position, the bottom part of the box cannot be fitted with
normal force; in this case the box has to be turned through
180°
The
figure shows the well positioned Ecobus Combi-connector outlet
Turn
on the pointed screws as far as they will go. Use a machine to
save time.
Clip
the hood(s)
